|
Reviving our 2011 Robot
We are putting our 2011 robot back together as a project, and I am having a few problems. The crio is formated to the 2012 image while I deployed the 2011 code that is using the old Labview librarys to reference thier vi's. (The only thing hooked up electricaly is the full setup to auto run the compressor). So I get Com, and Robot Code but the Volts say 0.00. I enable the robot and nothing happens, the relay light that the compressor is plugged into has no value. My question is if the relation between the 2012 image and 2011 code is causing this or what else going on.
ps. I built the 2011 code on the 2012 Labview.
~Thanks,
Jay
__________________
2013 Oklahoma Regional (Regional Winner, Gracious Professionalism, [and judges voted me star of the day ])
2013 KC Regional (Regional Winner, Woodie Flowers, Industrial Design)
2013 Hub City Regional (Regional Winner, Entrepreneurship, Quality, Dean's List)
|