|
Re: What's your CAD setup?
Quote:
Originally Posted by sanddrag
I'm surprised to hear that you're doing fine with 2GB of RAM for a full robot CAD model. Perhaps in SolidWorks.... All I know is in Inventor, I'm typically pushing over 3 or 3.5 gigs of RAM in use with a full robot model open.
|
Fine is a relative term. It works, but it would probably drive you crazy if you used it 8 hours a day for work. For the students to use them for a couple hours a day it's not too bad.
__________________
2001-2004: Team 100
2006-Present: Team 254
|