Thread: Bearings in Sheet Metal
View Single Post
  #6   Spotlight this post!  
Unread 18-11-2012, 20:44
Unsung FIRST Hero
JVN JVN is offline
@JohnVNeun
AKA: John Vielkind-Neun
FRC #0148 (Robowranglers)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 2000
Location: Greenville, Tx
Posts: 3,159
JVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond repute
Re: Bearings in Sheet Metal
If you use a flanged bearing, make sure it is well retained in the plate, and pinched axially on the shaft, you'll be fine even in something as thin as 063.

-John