We just got several of the new AM 4" performance wheels. Aluminum mag wheels for the robot, gotta love it. Very nicely made... should last a long time. I used roughtop for tread and found a few things:
1) Instead of shaving down the ends, if you get the bumps/waves of roughtop to interlock before inserting the 2 tread ends into hole it fits... just barely. You have to put the zip tie through the hole in the treads with a pair of needle nose pliers or hemostats AFTER you insert the tread through the hole.
2) In an attempt to eliminate/reduce the flat spot, I added "tabs" on the ends of the tread to keep the tread continuous on either side of the hole (see attached picture). Not sure it makes any difference as the flat spot is very minimal... but it looks nice and they lay flat.
3) The length of tread is slightly longer than the circumference of the wheel as the bending axis of tread must be near its center.
Attached is the flat pattern drawing.
