Quote:
Originally Posted by Gray Adams
Inventor comes in the KOP, so you're going to see a lot more people who have access to and use Inventor than Solidworks. A quick look at the subforums here says there are 7000 posts in the Inventor category, and about 800 in the Solidworks category.
|
Thats cause people understand SolidWorks better and it's easier to use
^Joke
But seriously i would go with Solidworks also. I have used all three, Solidworks is the easiest to learn and the most User Friendly. all you need to do is
Fill this out and get it in the Mail!