Quote:
Originally Posted by apalrd
I suspect there would be many destroyed 256:1 CIM gearboxes if that was true. The stall torque at the end of the gearbox would be ~560 newton meters.
|
Not to mention Banebots puts a max torque spec of 85 lb-ft or 115.2 N-m of torque on their P80 gearboxes.
As for the 2 vs 3 CIM Motors, correct me if I am wrong, but based off of this
http://content.vexrobotics.com/docs/...otor-specs.pdf
2 Motors at 300oz-in each will draw about 115 amps a piece. 230 amps total.
3 Motors at 200oz-in each will draw about 75 amps a piece for 225 amps total.
Because the curves are linear, total current draw shouldn't matter on number of motors. However, the motors will be rotating faster on the 3 motor setup at ~2200rpm compared to around ~700rpm because each motor has to put out less torque.