[tlivingd]

We're going to pick up the 20" length and can cut it short if we need to.

For the real prints drawing GE-13036 the dim is outside the circle, top left quarter of the circle at 10" dia.

For the team prints dwg TE-13001-11 its in the bottom right quarter outside of the circle also 10" dia.

I'm disappointed in the difference of the team drawings and field drawings for this important field piece.
1.5" OD bars on the real drawings, and 1.9" OD bars on the team drawings.

With my local suppliers, our cost for just the tower material is over $1000 for the real tower. About $800 for half with a complete top. Our team has a really tight budget, and for our team plans, an accurate tower is needed.

I need to contact a different supplier Monday on using an alternative tube than DOM (CRW, WHR, WCR, ERW) to see If we save some money.