[ctccromer]

Originally Posted by cgodzyk

All you need to change the code is to hit the run/deploy button on labview

Awesome, that's much better of a situation

So now I just need to figure out why my laptop can PING the cRIO but not find it when I try to image it. I'll test if LabVIEW can see it after school

as for the cRIO:

Originally Posted by ctccromer

Just did this and found out the cRIO's IP Address is "10.37.53.2". When I pinged it on my laptop, I saw these results. So I CAN ping it. My laptop DOES see it. Why can't the cRIO imaging program find it then?

A helpful friend from team 23 told me that the last digit of the IP address (the 2 bolded above) doesn't really matter on my laptop as long as it isnt taken by something else, and to use the mask/subnet "255.0.0.0" so that and "10.37.53.5" are what I'm trying to connect with