Quote:
Originally Posted by PhilBot
Hi
Over the last two days, I've had my NXT lock up twice during Teleop.
Fresh Batteries, New NXT, Correct Firmware, Correct template.
I have used some advanced Labview coding, but nothing that has been reported as not supported.
The weird thing is that when it happens, the NXT goes into that tick tick tick mode that occurs during a firmware update. The screen just freezes and you need to pull the batteries. Works fine on replacing the batteries.
Before I head down the long road of trying to get this to occur on demand, anyone seen anything similar with a well defined cause? No conjecture or speculation please.....
Phil.
|
Phil,
Any updates on this? While helping 4314 I encountered the same issue, However this happens very consistently using tether or samantha. I do hear the clicking noise a couple of seconds after enabling the robot.
The code is very basic. The only addition beside regular VI's is the hitechnic prototype board VI to read an analog.
Spent about 2 hours troubleshooting this with no luck.
While I have done some more advanced stuff in labview and I am a fan, The FTC implementation of labview in addition to the NXT has just been bad. And especially horrible this season. Just my opinion.