Thread: FRC Bridge Programming Error
View Single Post
  #5   Spotlight this post!  
Unread 11-01-2013, 18:32
Joseph W. Horth Joseph W. Horth is offline
Registered User
FRC #0280
  
Join Date: Sep 2010
Location: Michigan
Posts: 21
Joseph W. Horth is an unknown quantity at this point
Re: FRC Bridge Programming Error
Quote:
Originally Posted by Mark McLeod View Post
It's protesting that it cannot change the IP address of the computer you are running the Utility on.

Possibly you have other network connections Enabled?
Go to your Network adaptor settings and make sure all but the one Ethernet port you are using, are Disabled.

By the way, after the utility is done it may leave your computer's Ethernet IP set to 192.168.0.51 and you may need to change it back to DHCP or whatever you normally have it set to.
I tried disabling the other network connections but to no avail. Is there any other information I could be leaving out that would help?