Thread: General LabVIEW questions from a VERY new user
View Single Post
  #12   Spotlight this post!  
Unread 12-01-2013, 10:36
RufflesRidge RufflesRidge is offline
Registered User
no team
  
Join Date: Jan 2012
Location: USA
Posts: 989
RufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant futureRufflesRidge has a brilliant future
Re: General LabVIEW questions from a VERY new user
Try changing your motor Get Output VI to a Set Output VI. That should help with figuring out where to wire in the axis.
Reply With Quote