We assembled the VEXpro 3 stage Ball shifters today.
This post is to alert IFI and other teams of an issue with the assembly of the 3 stage transmission only.
Both of our transmissions had this issue and it took some investigation to find the exact issue.
There is a gap between the stamped metal plate that houses the third stage bearing and the 1/2" hex standoff's. If you install the plate it will bend and cause other problems. It appears that hex molded into the transmission housing is approximately .05" too deep as the 3D model measures .25" and the actual measurement of the molded housing is .30". One fix would be to add shims between the 1/2" hex and the metal plate.
