|
Re: Gears for the CIM motor shaft not going on.
SO.. In the past the gears have always just slipped on. Didn't see the vid before we assembled them so when they didnt just slip on I assumed it was just the plating gone bad causing the problem so we just ran an 8mm drill through them and on the went in the old way. Don't see why this would be a problem, the clip keeps them in place. Thoughts?
Bruce
__________________
Mentor Team 706 The CyberHawks
2010 Wisconsin Regional Rockwell Automation Innovation in Control Award
2010 Wisconsin Regional Finalist
2013 Buckeye Regional Finalist
2014 Superior Regional Industrial Design Award
2014 Superior Regional Finalist
2014 Wisconsin Regional Finalist
2014 Wisconsin Motorola Quality Award
2015 Wisconsin Regional Motorola Quality Award
2015 Queen City Creativity Award
2016 Buckeye Regional Finalist
2016 Wisconsin Regional Finalist
2016 Wisconsin Regional Industrial Safety Award
2016 Wisconsin Regional Excellence in Engineering Award
https://www.youtube.com/user/Cyberhawks706
|