Thread: Direct Drive CIM Through Toughbox
View Single Post
  #9   Spotlight this post!  
Unread 13-01-2013, 20:49
pfreivald's Avatar
pfreivald pfreivald is offline
Registered User
AKA: Patrick Freivald
FRC #1551 (The Grapes of Wrath)
Team Role: Mentor
  
Join Date: Jan 2007
Rookie Year: 2001
Location: Naples, NY
Posts: 2,295
pfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond reputepfreivald has a reputation beyond repute
Re: Direct Drive CIM Through Toughbox
I'm a big fan of robustness in FRC robots, and would not recommend having any drive shaft unsupported on one end as a general principle. You'll note in this picture that the long output shaft is supported at the edge of the robot by a pillow block.
__________________
Patrick Freivald -- Mentor
Team 1551
"The Grapes of Wrath"
Bausch & Lomb, PTC Corporation, and Naples High School

I write books, too!