|
Re: D-Link Bridge Communication
Check what your IP address/netmask are on your laptop before and after running as well as before and after using the Bridge Config Utility.
For that matter try browsing to the bridge before and after to see what IP is in use there.
I think the Bridge Config. Utility may be leaving your laptop IP as 192.168.0.51.
Then if your Driver Station is already running, it won't be able to connect to the cRIO.
Is your Driver Station set to change your laptop IP automatically whenever it is started?
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 14-01-2013 at 17:48.
|