Quote:
Originally Posted by Mark McLeod
"Set Motor Output" is what you are missing.
For example:
 |
Thanks! And since I have two separate motor controllers, I assume I need two separate Set Motor Output vi's? I tried plugging both motor controller RefNumRegistry vi's into each side of ONE Set Motor Output but the right side wouldn't connect
Just want to make sure I'm not messing anything up by having it with 2 (pic attached
Also in the picture, does wiring the right-most Set Motor Output's "Output" value to the other one's output value (as shown) give the same value as if I had wired the right-most Set Motor Output's "Output" value to the wire itself (before it plugs into the other vi)? (2nd pic attached since I'm bad at explaining)