Thread: Issues with servo
View Single Post
  #2   Spotlight this post!  
Unread 17-01-2013, 07:21
Greg McKaskle Greg McKaskle is offline
Registered User
FRC #2468 (Team NI & Appreciate)
  
Join Date: Apr 2008
Rookie Year: 2008
Location: Austin, TX
Posts: 4,751
Greg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond repute
Re: Issues with servo
Check the digital breakout board. You need a jumper next to the PWM to provide the correct voltage to the servo -- unfortunately. Also, make sure to run the DS and enable the robot.

Greg McKaskle
Last edited by Greg McKaskle : 17-01-2013 at 07:22. Reason: one more thing
Reply With Quote