[ArzaanK]

Hi

Just recently I have had problems deploying code onto the cRio. Everytime I try to deploy code onto the cRio, the terminal which shows the progress of the deployment stops and a window comes up that says "Failed to Connect to Real Time Target" These problems have only started this afternoon, and I have been able to connect to the cRio for the last week. Here is some extra info:

-I am using a cRio 2 with the following modules attached
- Analog Breakout
- Solenoid Breakout
- Digital Sidecar
-We are connecting directly to cRio via a crossover cable.
-The model of the laptop that I am using is an HP dv6-6153CA
-We also have this problem when using different computers and cables.

I have done the following to try and stop this problem:

- Make sure that the ip address is set to something that correlates with my tam number (i.e. 10.13.25.xxx) and the subnet mask is set to 255.255.255.0
- Restarting my computer
- Restarting the cRio
- Re-opening the project in LabView
- Restarting the robot.

Any help would be greatly appreciated.