|
Re: "Failed to connect to Real-Time target" error on one computer and not the other
Thanks guys,
The correct IP Address is in the labview project. I was able to ping the router and cRIO. I was also able to right click in the explorer window and connect to the cRIO but when it came to running the code, I would be disconnected and get the error in my original post.
No other networking connections are made beside the one connecting the computer to the router.
All firewalls and anti virus programs were disabled.
Typing ipconfig /all in the command prompt gave me back the expected results.
The dashboard was also closed the entire time.
I was able to single out where the problem started. The only computer able to successfully connect and submit code is the one that imaged the cRIO. No other computer is able to submit code.
Is there any known problem for an issue such as this?
|