So this is kinda related.
Our bridge has what I will call the red light of death at the moment and I wanted to see if anyone was able to help me with it.
I was able to run the configuration utility on the bridge without an issue and we successfully used the bridge without issues. Once we rebooted the robot the bridge refuses to boot with the red power light staying on (even on the AC adapter). I pressed and held the reset button while applying power to put the bridge into the firmware upload mode. I was able to load the web page without an issue, however every time I attempt to upload firmware it fails with the following message.
Code:
FAILED TO UPLOAD IMAGE
Unable to upload the image, please make sure the uploaded file is the correct image.
I believe I've read that you must unzip the file, however I have not been able to do that. Any suggestions?