[Pulverator]

I don't recall noticing anything on the drivers station, that's not to say I just didn't see it. I will definitely check to see what the readout says next time though, which might not be until Thursday unless another member can give it a try. We had the net console up at the time and the program just quits with a fatal kernel task exception.

We also had a lot of problems getting the debugger to work properly. I somehow got it working but I did not change anything that I know of, it just started to work. We have the same configurations (as far as I could tell) on my laptop and another team laptop and only mine can actually debug without it terminating too early. It's very frustrating. We can deploy new code fine, so that's not the issue.

I don't think this should matter but we over-installed WR with the 2013 version. We have updated workbench with both the 1/5 and 1/18 updates. We've gone through the documentation several times so I'm not sure why this is happening.

What errors do you get when you try to deploy code? You have the correct team number and x.out file selected correct?