Thread: cRIO imaging tool hangs on "Rebooting cRIO"
View Single Post
  #10   Spotlight this post!  
Unread 20-01-2013, 01:01
omalleyj omalleyj is offline
Registered User
AKA: Jim O'Malley
FRC #1279 (Cold Fusion)
Team Role: Mentor
  
Join Date: Jan 2008
Rookie Year: 2008
Location: New Jersey
Posts: 132
omalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to beholdomalleyj is a splendid one to behold
Re: cRIO imaging tool hangs on "Rebooting cRIO"
Quote:
Originally Posted by Alan Anderson View Post
We imaged a fresh cRIO this evening. It stuck at the "Rebooting cRIO" step. It took us a while, but we finally tracked down something that was misconfigured on our computer. Somehow the wired network interface had gotten two IP addresses set, and removing the extra one let everything work properly.

(I'm guessing the extra address ended up there when we selected the wrong interface in the D-Link configuration tool a half hour earlier, but I'm not about to go through that mess again to verify the cause of the problem.)

So I suggest that you double-check the "Advanced" IPV4 properties of your network connection and delete any superfluous entries.
Thanks Alan, this cleared it up for us. I had imaged an 8 slot cRIO with no trouble. After using the Bridge Configuration Utility nothing seemed to work when trying to reimage it, or another 8 slot we had. When I reset the IPv4 settings everything worked fine.
Reply With Quote