Quote:
Originally Posted by apalrd
I can't seem to find a CAN message spec for the Jaguar, so all of this is based on reading the LV CAN implementation and trying to figure out the messages.
|
The can protocol spec is included with TI's software development kit. Not sure if its still available. I couldn't find it from IFI.
Quote:
Originally Posted by apalrd
ISo yeah, if you built a purely isochronous system and sent the configs out at 5hz-20hz, periodic status at varying speed (maybe 100hz for status 0, 50hz status 1, etc. for more important data) and sent the Ackless motor command at 100hz, and never cared about the Ack message, you would be able to use a single thread and monitor them based on their Periodic Status messages in a single thread. They would configure themselves when they booted up within 200ms for the 5hz stuff and 50ms for the 20hz stuff, with no additional code to detect and reconfigure a reset Jaguar.
|
I think you'd run into bandwidth issues with the serial bridge with that scheme.