[ksafin]

It's fairly accurate. If you noticed, I had to hold it between my legs. The entire frame vibrates a lot when turned on, moving around the floor. If not held in place, it isn't consistent (obviously because its constantly moving and changing direction).

But yes, if held in place it seems fairly accurate.

Haha yeah quite the beast

Standard 8" pneumatic front and back at about 35 psi; I'm not sure what the compression was but I'll take a guess it was around 1/2" - 3/4". Not much. We didn't really measure it, just put our rail at the point where the compression seemed adequate.