Thread: pic: GT2 Pulleys
View Single Post
  #5   Spotlight this post!  
Unread 21-01-2013, 14:49
Mk.32's Avatar
Mk.32 Mk.32 is offline
Registered User
AKA: Mark
FRC #2485 (W.A.R. Lords)
Team Role: Engineer
  
Join Date: Jan 2011
Rookie Year: 2011
Location: San Diego
Posts: 770
Mk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud of
Re: pic: GT2 Pulleys
The pulleys were completely machined by me, the stock was a 3/8 6061 plate, which fits the 9mm tooth width perfectly.

Each pulley took about 20 mins to do on the machine, this includes the .5 hex profile as the bore.

The CAD model was downloaded from SDP SI's site.

I could run thinner flanges, they were just the thinnest piece I had and I was setup for that operation on the machine so whatever.
__________________
Engineering mentor: Team 2485: WARLords 2013-

Team President: Team 3647 2010-2013
Last edited by Mk.32 : 21-01-2013 at 14:55.
Reply With Quote