Thread: how to create a frc crio project?
View Single Post
  #3   Spotlight this post!  
Unread 22-01-2013, 07:18
Greg McKaskle Greg McKaskle is offline
Registered User
FRC #2468 (Team NI & Appreciate)
  
Join Date: Apr 2008
Rookie Year: 2008
Location: Austin, TX
Posts: 4,751
Greg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond repute
Re: how to create a frc crio project?
That screen gets overridden by the LabVIEW update. Please look on disk here

C:\Program Files (x86)\National Instruments\LabVIEW 2012\ProjectTemplates\FRC Templates

Leave out the (x86) if you are 32 bit.

If you do not have the FRC Templates directory and in that an Arcade and such, then the LabVIEW update has not been installed correctly. There have been some failed installs due to a .NET4 issue with something already on computers. I don't have the details, but would urge you to contact NI technical support via email or 866-511-6285 and let them help you.

A couple suggestions I'll give are to right-click on the update's setup program and Run as Administrator. And make sure you reboot after the install.

Greg McKaskle
Reply With Quote