Thread: Create a rectangle
View Single Post
  #1   Spotlight this post!  
Unread 23-01-2013, 07:02
matthewgkerr matthewgkerr is offline
Registered User
FRC #4529 (Team Melbourne)
Team Role: Mentor
  
Join Date: Jan 2013
Rookie Year: 2012
Location: Melbourne, Australia
Posts: 26
matthewgkerr is an unknown quantity at this point
Create a rectangle
Ok, so this is a real noob question. I'm trying to create a rectangle while i'm watching a tutorial. It says to select the rectangle tool (I think it is the two point rectangle) only I don't have that available. I have the 3D Sketch bar open, but all I see in the Draw tab is:
Line
Helical Curve
Arc
Spline
Equation Curve
Point Bend

I tried right clicking on the ribbon and customising the user command. I added Rectanle (Two Point) to Part | 3D Sketch, but I didn't see anything change in the Ribbon. Any suggestions?