|
Re: pic: Lots of chips
Quote:
Originally Posted by Redo91
By the looks of it, the roughing end mill was used to cut out the final piece. The inside cuts seem to have a nicer finish. This may have also been before a finishing cut.
|
This makes more sense. I haven't used our CNC much, I usually use the manual mills, so CNC techniques are sometimes a bit foreign to me, though I get the general concept and am proficient on our two knee mills.
__________________
Junior at the University of Notre Dame, Mechanical Engineering
Got questions (about Notre Dame, robots, college, etc), don't hesitate to ask.
**Bang Boom Pop!** "Was that the robot?" "I don't know, do it again"
**BANG BOOM POP** "Oh, now it's on fire."
|