|
Re: Inventor tutorials
If you open up the "Getting Started" page in the ribbon of Autodesk, there is a tutorial button. This will take to to a very complete list of tutorials, that I used when starting out.
IMO the built by design tutorials helped me very much.
Also, you can download Autodesk Sketchbook (sorry, I do not have access to the link right now), I know because we were able to do this right before build season. So unless they changed that since December, I think it is just on the downloads page, next to inventor and fusion.
Good luck, and PM me if you need any Autodesk advice.
__________________
 (Hanging out with my buddies at 610)
Robotics, it's not just a club, it's a career.
FLL Referee (2012-Present)
2014 Gateway Robotics Challenge winners (With 2481 and 1985)
2011 St. Louis Regional Winners (With 1985 and 3284)
2010 Highest Rookie Seed
I am the guy in the golden hat, say "Hi!" to me at WORLD CHAMPIONSHIPS!!!
|