|
Re: General LabVIEW questions from a VERY new user
The only timing VI's i found besides that one are all seemingly independent. The one attached above wires directly to a drive system. So I need one to wire directly to a SetMotorOutput vi. Or if not, then I don't know how to use one. Once again, all I'm trying to do is:
1) Send a motor control the value of -1
2) Wait 0.25 seconds
3) Send a motor control the value of 1
4) Wait 0.25 seconds
5) Send a motor control the value of 0 (and leave it that way until I call this function again)
__________________
Team 3753 BulahBots
|