Thread: Quick Solenoid question to clear up inconsistencies.
View Single Post
  #4   Spotlight this post!  
Unread 29-01-2013, 00:46
Cecil's Avatar
Cecil Cecil is offline
Registered User
AKA: Alex Hummel
FRC #2010 (Lightning Bots)
Team Role: Mentor
  
Join Date: Dec 2008
Rookie Year: 2006
Location: Champion
Posts: 343
Cecil is a splendid one to beholdCecil is a splendid one to beholdCecil is a splendid one to beholdCecil is a splendid one to beholdCecil is a splendid one to beholdCecil is a splendid one to beholdCecil is a splendid one to behold
Re: Quick Solenoid question to clear up inconsistencies.
If I remember correctly, the connector for the 24 volt area on the power distribution board goes V, C, NC, C (I don't have it next to me, I believe that's how it goes.) Hook your cRIO into the V and the C as you normally would, but then use the NC and remaining C to power your solenoid breakout. The cRIO will operate at a minimum of 9 volts (assuming you have the FRC cRIO II), but I wouldn't worry about the power draw against it.
__________________
I'm right 90% of the time, so why worry about the other 3%?