29-01-2013, 14:02
|
|
Passionate FIRST-er, CD donor
AKA: Gerry
 FRC #0578 (Red Raider Robotics) Team Role: Mentor
|
|
Join Date: Jan 2012
Rookie Year: 2008
Location: Rochester, NY
Posts: 256
|
|
|
Re: Using the 12v-5v converter for powering custom circuits?
That's fine, if you mean that you're going to use a second converter for this circuit. R44 says you must use a converter for powering the radio, and you can't connect anything else to it.
Quote:
R44:
The wireless bridge power feed must be supplied by the 12VDC-to-5VDC converter (P/N: CLL25-24S05) connected to the marked 12VDC supply terminals at the end of the PD Board (i.e. the terminals located between the indicator LEDs, and not the main WAGO connectors along the sides of the PD Board) shown in Figure 4?8. No other electrical load may be connected to these terminals.
|
__________________
Cal
R3: Red Raider Robotics (FRC Team 578)
Fairport, NY, USA
www.FairportRobotics.org
2016 Finger Lakes Regional: Semifinalist on Alliance 7 (1128, 2010, 578)
2016 NYC Regional: Finalist on Alliance 3 (3419, 578, 3017), 4th seed team, Team Spirit Award
2015 Finger Lakes Regional: 8-3-0 in qualification, 7th seed, Quarterfinalist
2014 NY Tech Valley Regional: 8-4-0 in qualification, 13th seed, Semifinalist
2013 Finger Lakes Regional: 4-5-0 in qualification, 26th seed, Alliance 6, 1-2 in tournament
2012 Buckeye Regional: Gracious Professionalism Award, 7-3-0, 14th seed
2011 Finger Lakes Regional: Engineering Inspiration Award
|