[gyroscopeRaptor]

We have been using RoboRealm to transfer vision information to our robot for processing. The setup on RoboRealm is working; it outputs the data we need to "NetworkTable". When we open up the SmartDashboard, it should automatically add values it is given, right? Like the values from RoboRealm?

But when we open up SmartDashboard the signal light remains red, and none of the values that are being sent appear.

We tried to reinstall RoboRealm, it worked for a very short period of time - the light was green and our values appeared, but it was apparently only temporary.

We are in dire need of help, so any advice or ideas are immensely appreciated.