Thread: CIM Motor Burn Out Question
View Single Post
  #8   Spotlight this post!  
Unread 31-01-2013, 12:41
jimwick's Avatar
jimwick jimwick is offline
jim wick
FRC #0885 (the Green Team)
Team Role: Engineer
  
Join Date: Feb 2006
Rookie Year: 2006
Location: tunbridge, vermont
Posts: 94
jimwick is a glorious beacon of lightjimwick is a glorious beacon of lightjimwick is a glorious beacon of lightjimwick is a glorious beacon of lightjimwick is a glorious beacon of light
Re: CIM Motor Burn Out Question
The CIM does not depend on air cooling. They are pretty tough to burn out. I very much doubt if there will be a problem.

To connect to the CIM get some hubs from Andy Mark. They have some that are specifically intended to mount any of their wheels to a CIM, 8mm shaft diameter as I remember. If you want to support the shaft above the wheel also just attach another hub and attach a short shaft into a bearing.