Thread: Assembling the FRC Andy Mark base
View Single Post
  #1   Spotlight this post!  
Unread 02-02-2013, 01:06
matthewgkerr matthewgkerr is offline
Registered User
FRC #4529 (Team Melbourne)
Team Role: Mentor
  
Join Date: Jan 2013
Rookie Year: 2012
Location: Melbourne, Australia
Posts: 26
matthewgkerr is an unknown quantity at this point
Re: Assembling the FRC Andy Mark base
Ok, well I figured out why I was getting stuck with #4. When I created the wheel/axle assembly, there was a constraint with the frame which was causing an issue. I assume I need to keep this broken constraint and repair it by associating it to the hole in the frame in the new location? But I'm not sure how I go about doing this. To get past the problem, I just deleted the constraint, but I'm sure that I have now broken all my wheel/axle assemblies. Help please.
__________________
__________________
Matthew Kerr
Engineering Mentor
Team Melbourne
Victoria Australia