Quote:
Originally Posted by cammy:)
Hello--
we have been recently trying to program a potentiometer, using LabView's potentiometer example VI on our robot. However, we are using a VEX potentiometer instead, and when we ran the code on our robot we did not get any voltage readings on the front panel or the FRC Driver Station. The program seems to be working fine, but it isn't reading any voltage from the potentiometer.
The potentiometer is currently wired into the analog breakout port 2. Do we need to wire it differently, or modify any parts of the program?
A little assistance would be much appreciated. Thanks!
|
Measure the power, signal, and ground pins at the pot with a handheld multimeter and post your results here.