Thread: Drills: The ball bearings are gone?
View Single Post
  #1   Spotlight this post!  
Unread 21-01-2003, 23:57
BobbyG BobbyG is offline
Registered User
#0433 (Firebirds)
  
Join Date: Jan 2003
Location: Philadelphia
Posts: 1
BobbyG is an unknown quantity at this point
Drills: The ball bearings are gone?
Year after year, I would open the top of the drill drive and all the ball bearings would fall out. In went the 6mm set screws and I would be done.
Is there anything special on this years drills to keep the clutch from slipping Joe?