|
Re: Changing Font size in Inventor?
Quote:
Originally Posted by theawesome1730
Did you draw (for lack of a better term) each letter, or did you use the text command? If you used the text command it is as simple as going into your sketch and editing the size. If you "drew" them individually I am not sure I know how to help you.
|
These are the dimensions that inventor put in when I used dimension tool. I can change font size for free-form labels, but not for measurements that Inventor put in.
__________________
 (Hanging out with my buddies at 610)
Robotics, it's not just a club, it's a career.
FLL Referee (2012-Present)
2014 Gateway Robotics Challenge winners (With 2481 and 1985)
2011 St. Louis Regional Winners (With 1985 and 3284)
2010 Highest Rookie Seed
I am the guy in the golden hat, say "Hi!" to me at WORLD CHAMPIONSHIPS!!!
|