Thread: pic: Team 3824 Chassis Pic 2
View Single Post
  #4   Spotlight this post!  
Unread 06-02-2013, 16:58
Mike Marandola Mike Marandola is offline
Lead Bumper Mentor
AKA: Mike Marandola
FRC #0316 (Lunatecs)
Team Role: Mentor
  
Join Date: Jan 2009
Rookie Year: 2008
Location: Pedricktown, NJ
Posts: 659
Mike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond reputeMike Marandola has a reputation beyond repute
Re: pic: Team 3824 Chassis Pic 2
Going off of the compressor (6") I was able to figure that the frame is roughly 22 inches wide. If a guard was added around the wheels on each side that was 3 inches, the width would then be bumped up to 28 inches. This would make the whole frame 28" x 28". This frame could very well be legal if something was added to make the wheels on the inside. Also the shafts look a bit to long so they could most likely be chopped which would give more wiggle room.
Reply With Quote