[Mark McLeod]

Netconsole was installed as part of the Utilities Update.
You'll find it under Start->All Programs->Netconsole for cRIO

Before using it you have to first have told the cRIO Imaging Tool that you want to use Netconsole (it downloads the cRIO side of Netconsole to the cRIO). See the attached picture. You only have to do this when you are imaging the cRIO. You don't have to do the reformatting part, just specify your language again and check Netconsole.

Start up Netconsole, then reset or boot your cRIO and you'll get a stream of OS messages as the cRIO loads VxWorks and then loads your program.
Some of the messages will be quite obscure, specifying version numbers and software being loaded, just look for later ones taking about Java.