Thread: PWM Channels Not Responding?
View Single Post
  #1   Spotlight this post!  
Unread 08-02-2013, 19:22
Team 4457 Team 4457 is offline
Registered User
FRC #4457
  
Join Date: Jan 2013
Location: Portland Or.
Posts: 16
Team 4457 is an unknown quantity at this point
PWM Channels Not Responding?
Hey, so here is our problem:

We are using two talons to run a four motor drive train (we are sure that that is not the problem) and we are correctly wired and all the wires work. But when we go to run the robot, only one of the two PWM channels work (this was determined by swapping around cables). The joysticks both work. Does this mean that this is a programing issue? If so, do you have any idea what is could be?

Thank you,
Team 4457
__________________
~There are always choices, some are just harder to make than others.~
Reply With Quote