[Greg McKaskle]

I'm sorry if my post was confusing. I was explaining how to create an image that you would then wire into Dst.

I believe the general rules for image VIs are that with no Image Dst, it will attempt to use Image Src for the output image. If that won't work, it will return an error.

If you wire an Image Dst, it will leave Image Src alone and will place the output into Image Dst.

There is also the technique of branching the wire and wiring a single image to both Src and Dst. I believe this is similar to leaving Dst unwired. The help for the various Vision VIs will contain details about Src and Dst requirements.

Greg McKaksle