Thread: Axis camera m1011
View Single Post
  #2   Spotlight this post!  
Unread 10-02-2013, 12:28
Greg McKaskle Greg McKaskle is offline
Registered User
FRC #2468 (Team NI & Appreciate)
  
Join Date: Apr 2008
Rookie Year: 2008
Location: Austin, TX
Posts: 4,751
Greg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond reputeGreg McKaskle has a reputation beyond repute
Re: Axis camera m1011
Most of the setup apps require that you configure the network IP to place the computer and device on the same subnet first.

For the camera, if you are unsure of its IP, hold the reset button for ten seconds when powering it and it will reset to 102.168.0.90. Set the PC to a 192.168.0.6 or similar IP and you should be able to log into the camera for manual configuration or using the setup tool.

I believe the radio programming tool may set the IP for you.

The cRIO imaging tool does not.

Greg McKaskle
Reply With Quote