Thread: CRIO Image tool won't recognize pneumatic breakout
View Single Post
  #1   Spotlight this post!  
Unread 12-02-2013, 19:27
Joe Ross's Avatar Unsung FIRST Hero
Joe Ross Joe Ross is offline
Registered User
FRC #0330 (Beachbots)
Team Role: Engineer
  
Join Date: Jun 2001
Rookie Year: 1997
Location: Los Angeles, CA
Posts: 8,585
Joe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond reputeJoe Ross has a reputation beyond repute
Re: CRIO Image tool won't recognize pneumatic breakout
Yes, it should be slot 3. If you look at the cRIO slot 3 pins, do you see any damage? A bent pin would cause the module to not be detected.