[toastnbacon]

Originally Posted by Mark McLeod

Here's something to try.

On the Driver Station Operation tab, put the robot into Test mode and Enable it.
Then on the Dashboard Test tab, you will see a listing of all the things you opened in Begin.vi.
Find the servo and click on value.
Controls will appear at the bottom of the tab window that let you move the servo to see if it responds properly.
If it appears the the Test window, then the servo was Opened.
If you can control it, then the wiring is good.

I love this! Thanks for sharing!

But as to the servo, I would try only recalling one joystick 3, having two might give the not a headache.