Thread: Retaining clip question
View Single Post
  #3   Spotlight this post!  
Unread 14-02-2013, 22:27
Tristan Lall's Avatar
Tristan Lall Tristan Lall is offline
Registered User
FRC #0188 (Woburn Robotics)
  
Join Date: Aug 2001
Rookie Year: 1999
Location: Toronto, ON
Posts: 2,484
Tristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond reputeTristan Lall has a reputation beyond repute
Re: Retaining clip question
If 98430A132 is what you need, see here. The shaft diameter tolerance band includes Ø8 mm (Ø0.314960 in), so it should work.

If it's another part instead, it's only 0.0025 in different, so it's very likely to work fine.