Thread: Servo not responding
View Single Post
  #1   Spotlight this post!  
Unread 16-02-2013, 12:19
saberboy117 saberboy117 is offline
Registered User
FRC #1870
  
Join Date: Jan 2013
Location: Alberta
Posts: 9
saberboy117 is an unknown quantity at this point
Servo not responding
So our robot has a servo that we are trying to get working. Its hooked up to the PWM outputs on the digital side car next to our motors. No matter what we do it wont respond. Its not even powered! In labview I have it using the set angle function. Am I doing somthing wrong? such as when initalising the servo do I need to input the angle variable? Am I using the wrong function? is it pluged in wrong? When I use the same PWM port on a motor it works fine. Any ideas?