[RoboRealm]

Assuming you know the IP address, you will have to login into the camera and switch it to the team's static IP address that Greg mentions. That's the tricky part if you are not familiar with DlInk browser interfaces (this is basically similar to the Axis but the interface is different.)

Once that is done, load in the DLink module within RR and select the 900 series, enter in the right IP address and any username/password if you set that. Once you press the start button it should start showing the image within RR.

Then access the Options button->Web server tab. Switch that on (its a checkbox) and change the port from 8080 to 80. Press ok to get back to the main RR interface.

Then jump into LabView/Dashboard/etc. and use the RR's IP address (maybe its 127.0.0.1 if you are running it on the same machine) as the camera's IP address. LabView will then access RR as if it were an Axis camera which will stream the image from the DLink.

Try it step by step, getting all the IP's correct and finding/resolving issues at each step is the way to do this.

STeven.