|
Slowing down the output signal from a spike
Hey CD,
I have a very quick and simple question.
The motors we are using to run a conveyor belt runs pretty fast. We did not take this into account when designing the robot and therefore we connected spikes to these motors.
Now when we tested it out, they move to fast, so is there any possible way to maybe instead outputting 100% power from the spike, outputting only 50%. Or do we have to put on jaguars
__________________
 RAMAZOIDZ
2009 Toronto West Regional - Regional Winners
2009 Waterloo Regional - Regional Winners
Last edited by 2185Bilal : 02-17-2013 at 05:25 PM.
Reason: typo
|