|
Re: Jaguar can issue
It probably isn't breakers tripping since the status light goes to neutral, not off.
Have you tried a simple program, your program might be resetting it somewhere. Have your program output what it thinks the motor voltage should be.
Is your firmware up to date?
Are you using the serial to jaguar bridge, or a 2can?
Does the driver station report any errors?
Do you have a 100-120 ohm terminator at the end of the chain? If you are using the serial to jaguar interface do you have a terminator on that end as well?
__________________
2017 Shenzhen, China Regional CSA
2013 - Present MAR Control System Adviser and FTAA
2009 - Present Programming an Electrical Mentor Team 41
2007 - 2008 Team 41 Lead Programmer, Electrical
2005 - 2008 Team 41 Member
2008 NYC Regional Winner
|